within it (except when this manual provides specific instructions directing you to do so). Refer all servicing to your retailer, the nearest Roland/. Edirol Service. Easily share your publications and get them in front of Issuu’s millions of monthly readers. Title: Edirol V8 Manual, Author: Andrew Psy, Name: Edirol V8 Manual. within it (except when this manual provides specific instructions directing you to do so). Refer all servicing to your retailer, the nearest Roland. Service Center, or .
|Published (Last):||1 May 2018|
|PDF File Size:||19.83 Mb|
|ePub File Size:||16.28 Mb|
|Price:||Free* [*Free Regsitration Required]|
Before using this unit, carefully read the sections entitled: Repeatedly Layering An Image Onto Itself feedback By returning the output image of a video mixer back to the input and mixing it with the original image, you can produce the effect of the image repeatedly layered with itself Feedback.
Panel Descriptions continued Rear Panel fig. Appendices Troubleshooting If you suspect a malfunction, please check the following points. Table of Contents Add to my manuals Add. If an image is being input to both connectors of the same channel, the input from the S-video connector will take priority.
The factory preset settings are assigned to memory number 1. Page 80 Could you have switched off power before closing a menu? Page Transition Effect List continued Could you have switched off power before closing a menu?
Basic Operation continued About the Current Settings Display You can use the preview monitor to view the current settings. Page of Go. When V-LINK mode is turned on, the V-8 can manuwl controlled from the external device to switch the video output or image. These sections provide important information concerning the proper operation of the unit.
EDIROL V-8 Owner’s Manual
Don’t show me this message again. This will be ignored if received. Adjusting The Video Fader Use a Phillips screwdriver to remove the four screws shown in the illustration. Play back your video device.
Page 86 Returns the sub-menu settings to the factory- set state. Page N Using Effects continued Using Chroma-Key to Combine Images When you apply chroma-key compositing to the image of a bus, the area of the key color will become transparent, and the image will be combined with the image of the other bus. Using Effects continued Using Multi-Screen You can divide the screen horizontally and vertically to display the input image.
Using Luminance-key To Combine Images Using Effects continued Using Luminance-Key to Combine Images When you apply luminance-key compositing to the image of a bus, the bright or dark area will become transparent, and the image will be combined with the image of the other bus.
The settings will be recalled. Of the input channels 1—8, S-video input is available only for channels 5—8. Page Transition Effect List continued Stretch Transition This transition stretches the new image across the previous image. Don’t have an account? The next byte transmitted is 0CH.
EDIROL V-8 OWNER’S MANUAL Pdf Download.
When you operate the video fader, the transition effect will change depending on the fader position. If this occurs, proceed as follows to calibrate the video fader. Page Transition Effect List continued Slide Transition The effect to slide out the present image and slide in the another. No part of this publication may be reproduced in any form without.
Effect List continued Effects that Cannot Be Used Simultaneously For effects that cannot be used simultaneously, the effect name in the information about the settings p. Mix Trans1 [Mem2]—[Mem8] Page 50 – Repeatedly Layering an Image onto Itself Transition Effect List continued Stretch Transition This transition stretches the new image across the previous image.
Index Index Effects continued Symbols Feedback Block Diagram Block Diagram Page 61 – Switching Images at the Tempo Specified